2019-01-09 21:28:45.780
000 > 00 8A A6 8A 9E 40 40 60 92 AE 68 88 AA 98 61 80 FF F0 05 7A
020 > F2 F2 0F 34 D0 00 00 FF F7 FF FF 00 00 00 00 43 03 23 03 00
040 > 00 00 00 00 00 00 00 00 70 10 00 00 00 00 00 00 00 00 00 00
060 > 40 00 7E 3E D1 30 00 00 00 00 00 7C 60 30 00 00 00 00 00 00
080 > C6 00 B0 00 EF 00 B6 00 AD 00 A1 00 B7 00 B6 00 B8 00 C3 00
100 > AF 00 00 00 00 00 00 40 00 00 0B 00 3F 00 00 00 00 00 03 00
120 > 00 00 00 00 00 00 FF FF BF 11 00 00 00 00 00 00 00 00 00 00
140 > 00 00

type 3 (OBDH)
-------------
OBD_MODE : 242
OBD_OLD_MODE : 242
OBD_ACTIVE_TASK : 15
OBD_EQUIPMENT_STATUS : 53300
OBD_EQUIPMENT_HEALTH : 4294965247
OBD_CPU_ERROR : 0
OBD_CAN_STATUS : 52626243
OBD_PLCAN_M_ERROR : 0
OBD_PLCAN_R_ERROR : 0
OBD_PYCAN_M_ERROR : 1077248
OBD_PYCAN_R_ERROR : 0
OBD_CAN_TIMEOUT_ERR : 0
OBD_HK_STATUS : 2113945600
OBD_POWER_TIME : 283471040830 s
OBD_MODE_TRANSITION : 549758984316 s
OBD_WD_RESET_COUNT : 0
OBD_TEMP1_PDU1 : -5.8 C
OBD_TEMP2_BAT1 : -8 C
OBD_TEMP3_PMB : -1.7 C
OBD_TEMP4_HPA2 : -7.4 C
OBD_TEMP8_HPA1 : -8.3 C
OBD_TEMP10_TNK : -9.5 C
OBD_TEMP11_BAT2 : -7.3 C
OBD_TEMP12_MWM : -7.4 C
OBD_TEMP13_MWR : -7.2 C
OBD_TEMP14_MMM : -6.1 C
OBD_TEMP15_MMR : -8.1 C
OBD_RS422M_ERR_COUNT : 0
OBD_RS422R_ERR_COUNT : 0
OBD_HK_ERROR : 16384
OBD_RS422_STATUS : 4128779
OBD_RS422_ERROR : 0
OBD_RS485_STATUS : 3
OBD_RS485_ERROR : 0
OBD_STATUS : 297795583
OBD_ERROR : 0
OBD_TEMP_ERROR : 0
OBD_ERROR : 0
OBD_TEMP_ERROR : 0

interval: 5 min

SDRSharp_20190102_124605Z_436980000Hz_IQ.wav

I found the reason “It can be decoded at -5 kHz lower tuning below the carrier”
that UZ7HO said. Looking of the reception figure above which received me on
2 Jan 2019, it will be decoded at that moment when the signal began to hear
in Soundmodem. You can see 9k6 spectrum in the FFT of SDR# at the beginning
of the signal. It’s the red arrow part in the figure above.

The red vertical line at the center of the 16 kHz width filter is -5 kHz lower
tuning below the carrier. In other words, it was decoding 9k6 in Soundmodem
when I put the red vertical line at 436.9958 MHz in SDR# FFT in the case of
the figure above. It meant that it was “-5 kHz lower tuning”.

Happy New Year

 
Andy, UZ7HO said you should tune your radio -4800hz below the carrier,
and I, JE9PEL confirmed this IQ.wav file had the highest decoding
possibility at 436.987 MHz below -7 kHz carrier. (1st Jan 2019)
SDRSharp_20181231_123947Z_436970000Hz_IQ.wav
je9pel_31122018_2341.kss